Y Link Extension fits 2.5" - 4" lifts

$68.58
OR

Quick Overview

This bracket set is to extend the mount on the top of the rear axle for a 4" lift. The bracket allows you to use the factory Y link with lowering the rear 4" and still get good articulation with the rear axle .

NOTE: the cast housing in this picture is for display purposes only.

Installation Notes
install time: 0.5 - 1 hour
instructions: Down load PDF

Details

This bracket set is to extend the mount on the top of the rear axle for a 2.5-4" lift. The bracket allows you to use the factory Y link with lowering the rear several inches and still get good articulation with the rear axle .
 
NOTE: the cast housing in this picture is for display purposes only.
 
Installation Notes
install time: 0.5 - 1 hour
instructions: Down load PDF

Additional Information

Manufacturer No
Variant 1

Customer Reviews

CLUNKING Review by Rik
I installed this link on a 2002 Liberty with a 2.5" lift. It seemed like a logical idea, but I imediately ran into problems. First the holes were not drilled right. I had to use a dremel to correct the distance between the holes. Then when I reinstalled the link I got a CLUNKING sound. I don't know if it was the rear sway bar hitting the bolt head on the front of the link or the link itself. All I know is when I went back to the original setup the CLUNKING went aways.
Like I said, it seems like a logical idea. It just didn't work for me or my setup. (Posted on 11/11/2016)

Write Your Own Review

Only registered users can write reviews. Please, log in or register