JBA Upper A-arms for 08-12 lifted Jeep Liberty's
$395.95
In stock
SKU
JBA-5.5.00
The JBA Upper A-Arms were designed for your lifted Liberty and will directly replace your stock upper a-arms.
The JBA Upper A-Arms were designed for your lifted Liberty and will directly replace your stock upper a-arms. The original equipment a-arm hits the spring, which causes premature ball joint failure on Liberty's with a lift kit. The JBA A-Arms are compatible with all the lift kits on the market today! These A-Arms were designed to fit on 2007 through 2012 Jeep Liberty's. Made of heavy duty tubing, red powder coat finish, with replaceable ball joints and factory rubber bushings. The A arms are assembled and ready to bolt onto your Liberty. Sold as a set, 1 left & 1 right UCA.
Note: a-arms are not symmetrical match the left to the left & the right to the right.
As seen in Low Range, J-Rations, Jp-Freek, 4 Wheel Drive and Sport Utility Magazine!
-
Gen 5.5 A-arms
-
Ball joints are mounted on an angle to line up with steering knuckle
-
No tire rubbing
-
3/8" more strut clearance than factory arms
-
Factory front end alignment
-
Replaceable ball joints
-
Red powder coat finish
-
Heavy duty tubing
-
2007-20012
-
A-arms work with all Jeepin by Al lift kits!
-
Sold as a set
Installation Notes
install time: 1-3 hours
Variant | 1 |
---|
Write Your Own Review